16. Assume that point D is the operating point on the transfer
characteristic in figure 3-6, and a 6-volt peak-to-peak signal is
applied to the grid.
The plate current will then vary between the
5 and 22 mA.
7 and 20 mA.
7 and 13 mA.
13 and 22 mA.
17. Assume that you are using the dynamic transfer characteristic in
figure 3-6 to determine the plate-current waveform for a triode
circuit biased at -7 volts (point G). If the input signal shown in
figure 3-7 is applied to the grid, the plate-current waveform will be
most like the waveform shown in figure 3-7 in the sketch labeled.