Lesson 1 - MM504470005
Introduction
Introduction - Continued - MM504470007
Introduction - Continued - MM504470008
Figure 1.
Locate the following chassis on the Control Indicator Group
Locate the following controls on Panel
Locate the following controls on the Control Radar
Locate the following controls on the synchronizer-generator chassis
Locate the following controls and test points on the navigational computer chassis
Figure 6.
Figure 7.
Locate the CUR LIN ADJ
Locate the Radar Set Group OA-2665/FPN-40
Locate the following components on Radar
Locate the following chassis on the RT group
Locate the following controls on the control monitor chassis
Locate the following controls on the Power Supply PP-2489/FPN
Locate the azimuth scan protractor on the Antenna Pedestal Subassembly
Locate the precision drive handwheel on the Antenna Pedestal Subassembly
Place the following controls on the Control Monitor
Depress the HIGH VOLTAGE OFF Button S-2302 on the Power Supply
Examine the azimuth scan protractor on the Antenna Pedestal Subassembly
Rotate the precision drive handwheel until the azimuth scan protractor
Figure 19B.
Rotate the precision handwheel and set the azimuth antenna
The ARTIFICIAL ANGLE VOLTS can be used to reference
Figure 21.
Place ART EL-OPERATE-ART AZ Switch S-401 on the navigational computer
Lesson Steps Checklist
Performance Actions
Performance Actions - Continued
Perform the Following on the navigational computer chassis
Performance Actions - Continued
Have your supervisor/trainer check your work
Performance Testing
U.S. Army Aviation Center
Introduction
Introduction - Continued - MM504470007
Introduction - Continued - MM504470008
Figure 1.
Locate the following chassis on the Control Indicator Group
Locate the following controls on Panel
Locate the following controls on the Control Radar
Locate the following controls on the synchronizer-generator chassis
Locate the following controls and test points on the navigational computer chassis
Figure 6.
Figure 7.
Locate the CUR LIN ADJ
Locate the Radar Set Group OA-2665/FPN-40
Locate the following components on Radar
Locate the following chassis on the RT group
Locate the following controls on the control monitor chassis
Locate the following controls on the Power Supply PP-2489/FPN
Locate the azimuth scan protractor on the Antenna Pedestal Subassembly
Locate the precision drive handwheel on the Antenna Pedestal Subassembly
Place the following controls on the Control Monitor
Depress the HIGH VOLTAGE OFF Button S-2302 on the Power Supply
Examine the azimuth scan protractor on the Antenna Pedestal Subassembly
Rotate the precision drive handwheel until the azimuth scan protractor
Figure 19B.
Rotate the precision handwheel and set the azimuth antenna
The ARTIFICIAL ANGLE VOLTS can be used to reference
Figure 21.
Place ART EL-OPERATE-ART AZ Switch S-401 on the navigational computer
Lesson Steps Checklist
Performance Actions
Performance Actions - Continued
Perform the Following on the navigational computer chassis
Performance Actions - Continued
Have your supervisor/trainer check your work
Performance Testing
U.S. Army Aviation Center
