119
one
120 The reference dimension of the first block
in the 9-block series is 0.1001 inch. The sec-
ten
ond block in the 9-block series would be equal
to 0.1001 inch plus the series increment of 0.
thousandth
0001 inch or
_______________answer
138
numbers
139 The
3 is in the first decimal place and re-
presents
a dimension of three-tenths of an inch.
first
The 2 is
in the _______ ___________ place and re-
presents
two-hundredths of an inch.
second
places
158
selection
159 Each significant digit to the right of the
decimal point in a reference dimension must be
principles
eliminated by subtracting a gage block dimension
which has the same number in the _________ deci-
mal ______________ as the reference dimension.
178
gage blocks
179 After you transfer the accuracy and dimen-
standards
sions of the gage blocks to the micrometer as
dimensional
shown in foldout-2, you can use the micrometer
accuracy
for various measurements. The setting of the
direct
micrometer is a _______ application of gage blo-
application
cks, but the micrometer measurements are ________
applications.
197
standard
198 When you use gage blocks to establish the
distance between the anvil and spindle of the
gage
snap gage, the application is ________________.
However, when you use the calibrated gage to
block
check a part, the gage block application is
_____________.
216
Response for 216 is located
on page 26.
24
Previous Page
