121
122 The blocks of the 9-block series increase
Nr
3
-
0.1003
in reference dimensions from the smallest to the
Nr
4
-
0.1004
largest in increments of ____.____________ inch.
Nr
5
-
0.1005
Foldout-1 indicates that the second series con-
Nr
6
-
0.1006
tains __________ blocks which increase from the
Nr
7
-
0.1007
_________ to the _____________ in increments of
Nr
8
-
0.1008
0. __ __ __ inch. (one-thousandth inch)
Nr
9
-
0.1009
140
digits
141 In selecting blocks for a given dimension,
start with the number in the last decimal place.
numbers
In the dimension 0.3200 inch, a zero is in the
___________ decimal place which is the last
_____________ ____________ .
160
eliminate (subtract)
161 In the dimension 0.4560, the last signifi-
cant digit is _______ . To eliminate the number,
digit
select a block, from the 81-block set, whose
dimension has the __________ number in the same
_____________ ______________ .
180
direct
181 At this point we have completed our discus-
sion of a typical application of gage blocks.
indirect
We have said that the dimensional ______________
and the dimensions of gage blocks can be used
to ________________ the scales of a micrometer.
199
200 The devices you have listed have certain
components which are common to the three devices.
visual gages
In each case, gage blocks are placed between a
_______ and an ________ to establish the desired
snap gages
dimension.
217
gage
218 When a device which is calibrated with the
sine bar- ________ ________ combination of fold-
blocks
outs 6 and 7 is used to calibrate another device
the gage block application is _________________ .
direct
28
Previous Page
