123
dimension
124 The first block in the 49-block series is
0.0001
0.101. Using the foldout-1 and the addition
0.001
procedure used with the 9-block series, you know
one ten-thousandth
that the dimensions of the second and third
one-thousandth
blocks in the 49-block series are _._ _ _ inch
and _._ _ _inch.
142
zero
143 The selection of a gage block to eliminate
the ___________ in the third decimal place of the
measurement 0.3200 inch is not necessary because
the ________ is not a _________ ___________ .
162
second
163 After you subtract the dimension 0.106 from
the overall reference ____________ (0.4560), you
0.106
will ____________ the last _________ ___________
(__) from the remaining reference dimension.
182
direct
183 In relationship to the measurements made
the calibrated micrometer, the use of the
gage block(s) is an __________ application.
201
202 When gage blocks are used to calibrate di-
visual
mensional measurement devices such as ___________
gage
______, ______ , and _____ _____ , direct
snap
applica-
gage
tions of gage blocks are made. When the measure-
direct
ment device is used to check other devices, the
indirect
gage block application is ___________________ .
219
direct
220 The direct and indirect gage block applica-
indirect
tions discussed in this chapter have been asso-
gage
ciated with dimensional and angle measuring de-
blocks
vices such as _________ , _________ __________ ,
_________ __________ , and the _______ _______.
32
Previous Page
