17
rectangular
18
Gage block shapes are identified by the
inventors' last names. The square block is
called a ______ block and the rectangular block
is called a ______________________ block.
35
36
36
List in any order the number of blocks
contained in the gage block sets which are
40
most widely used.
________
________
81
________
________
________
52
rust
53
You should use a chamois or soft cleaning
tissue to remove the rust proof grease from
proof
the gage blocks. Cleaning materials other than
a ________ or ________ ________ ______________
grease
may scratch the mating surfaces of the blocks.
72
73
When the temperature of the gage block or
68 F.
the piece to be measured is above the standard
2 F.
temperature of ________ ________ , you should
not perform your measurement until both the
block and the piece return to values within the
71 F.
____________________ temperature range.
75 F.
92
93
The preceding wringing procedure is not
used by all calibration laboratories. Although
it is an established ___________ , other proce-
No Response Required
dures have been ___________ for ____________
109
length
thickness
CONTINUE WITH FRAME 110 AT THE
TOP OF PAGE 4
37
Previous Page
