128
dimensions
129 Look at foldout-1 again and locate all re-
ferences to the 4th series of blocks. You can
0.900
see that there are _______ blocks which vary in
_________ from ____ inch to ____ inches in series
0.850
increments of ____ inch.
(CONTINUED ON PAGE 4)
147
0.001
148 If we add the value of 2 series increments
to the value of the first block, the total value
0.101
is _____ inch which is the dimension of the _____
block in the series.
(CONTINUED ON PAGE 4)
167
gage
168 In addition to the measurement shown in
blocks
Figure 11, _______ applications are made when
direct
you use gage blocks to calibrate other dimen-
application
sional measuring equipment.
(CONTINUED ON PAGE 4)
186
187 When you adjust the FINE ZERO knob on the
_______ ______shown in foldout-3, you are posit-
ioning the gaging __________ so that it will
No Response Required
barely ________ the top block of the gage block
combination.
(CONTINUED ON PAGE 4)
206
pins
207 Illustrations A and B in foldout-6 show
that the length ____ is the hypotenuse of a right
L
triangle. We can say that L represents a ______
____ whose __________ (distance between pin cen-
ters) is the ______________ of a right _______ .
(CONTINUED ON PAGE 4)
42
Previous Page
