INTRODUCTION:
1. The lesson on test-operate doppler set allowed you to get familiar with
the doppler set and the operating procedures for the doppler.
The skills
that was covered in that lesson is one of the skills that is needed to
locate a faulty component. Once you have replaced a faulty component, the
job of troubleshooting is completed.
But you must be able to locate and
identify the component that has to be replaced and this will be covered in
your next lesson.
2. In this lesson you will go through the procedures which will help you to
remove and replace components of the lightweight doppler set.
You will
practice replacing the components of the doppler set to reinforce your
understanding of this lesson.
At the end of this lesson your supervisor
will check your ability to perform this task.
17
Previous Page
