3.
When should you use the unit troubleshooting chart?
a. Before operation, by IDS maintenance personnel.
b. During operation, by unit level maintenance personnel.
c. After operation only.
d. None of the above.
4.
During operation of an LDF it was found that the input and output
copy was scratched or marred. What is a possible cause of defect?
a. Handset defective.
b. Print stylus jamming.
c. Loss of power.
d. Document pads dirty.
5.
During the POWER-ON-DIAGNOSTIC test, how does
the
front
panel
indicate that the CPU test is being performed?
ERROR LED
MEMORY LOAD
SEND LED
RCV LED
a.
ON
ON
ON
ON
b.
FLASHING
OFF
ON
ON
c.
FLASHING
OFF
ON
OFF
d.
FLASHING
ON
OFF
OFF
6.
During the receive operation of the LDF, it was noted that the
print stylus was jamming. What is the corrective action?
a. Check the switch settings for proper set-up.
b. Clean stylus pivot assembly.
c. Separate margins stop.
d. Replace transducer assembly.
10
Previous Page
