115
series
116 The number one in the series increment
increment
of the first series is located in the ten-
thousandth of an inch position. This means
0.0001
that the series increment spelled out is one
________ - ___________________of an inch.
134
third
135 Note that in frame 134 you were not
concerned with numbers on the left side of the
fourth
decimal point. Decimal places are located on
the __________ side of the ________ __________ .
places
154
combination
155 Recall that the third series of the
81-block set contains _______ blocks. The di-
dimensions
mension of the smallest block is ________ inch
and the series increment is __________ inch.
0.2000
174
dimensional
175 With proper pressure applied by the
___________ of the micrometer, the micrometer
accuracy
___________ and _________ will barely contact the
gaging surface of the gage blocks.
193
direct
194 Notice that the ____________ gage in fold-
indirect
out-4 is equipped with a dial indicator which
has a ____________ indicator _____________ .
visual
gages
212
opposite
213 Turn to foldout-7. Since the side of
the right triangle opposite the unknown angle
is equal to h2-h1, the gage block dimen-
sions in illustration A can be used to find
the length of the side opposite the angle
in B. This length is ______________ inches.
16
Previous Page
