5
reference
6
Gage blocks are commonly available in
plain steel, chromium-plated steel, and car-
standard
bide. The two types of steel are ___________ and
___________ ____________. The other material
measurement
commonly used is _______________ .
24
Hoke
25
We want to be sure that the two sur-
faces are ____________ so that the ____________
parallel
measurement dimension exists for all points on
the gage block surfaces.
42
flat surfaces
43
Let us remember that when we discuss
gage block features, increased accuracy is our
parallel surfaces
primary goal. Gage blocks must be constructed
with the highest degree of ____________ possible
low temperature
in order to qualify as a ____________ _________ .
coefficients
60
drop
61
If you _____
a gage block or _________ it
____________ , you will have to check the
handle
block to see if the __________ it has received
has changed the __________________ accuracy of
roughly
the block.
80
wring
81
The process of ____________________ gage
blocks is easier when the mating surfaces are
covered with a thin grease film. If gage
blocks do not adhere with a force of several
hundred pounds per square inch, you may have
to place a ______ ____________ __________ on the
mating ___________ of the blocks.
99
overlap
100 If you continue the motion illustrated
gaging
in Figures 6 and 7, you can complete the wring-
surfaces
ing procedure so that the gaging ___________ of
pressing
lightly
Figure 8 at the bottom of page 15.
sliding
13