112
series
113 Each of the four series of gage blocks
shown in foldout-1 is composed of a preselect-
ed number of blocks. The first of the four
_______________ contains 9 blocks.
131
132 By selecting and wringing combinations
of blocks from our 81-block set, hundreds of
reference dimensions can be obtained. If the
reference dimension of block "A" is 0.050 inch
No Response Required
and the dimension of block "B" is 0.150 inch,
the ________________ of blocks can be used to
set calipers for a measurement of _________ inch.
151
last
152 When we subtract 0.1200 inch from
0.3200 inch, the remainder is ___________ inch.
digit
This means that we still have to select a
block or combination of blocks to eliminate
the remaining significant ____________________ .
171
standards
172 Look at foldout-2. Since the gage
blocks shown are used to transfer the __________
measurements
________________of the gage block to the micro-
meter, we see a ___________ application of gage
blocks.
190
0.1005
191 The principle used in adjusting the
0.119
Visual gage for a specific dimension (0.3195)
0.100
is the same as the principle used when a mi-
0.3195
crometer is adjusted for a __________ _________ .
In both instances, a _____________ ____________
indirect of gage blocks is made.
209
gage
210 You can see that the right triangle in
Figure B consists of a hypotenuse (L) provided
block
by a ________________ , an opposite side (opp)
provided by the _________________ stack dimen-
sion (h2-h1), and an adjacent side (adj).
10
Previous Page
