LESSON 3
PRACTICE EXERCISES
(PERFORMANCE-ORIENTED)
L03:
MODE A and B Operation of the AN/UXC-7
TASK:
Receive and send in Modes A and B, load the memory, and use as
a copier.
CONDITIONS:
Given Lesson 3 material, TM 11-5815-615-10, pencil, paper, and
without supervision.
STANDARDS:
Demonstrate competency of the tasks by correctly responding to
70 percent of the practice exercise questions covering Lesson 3.
(Refer to TM 11-5815-615-10.)
INSTRUCTIONS:
In each of the following exercises, SELECT the one answer that BEST completes the statement
or answers the question. Indicate your response by circling the correct letter below.
1.
In order to keep transmission time to a minimum, messages should be composed so that the
entire message, including signatures, is positioned
a. as close to the bottom of the page as possible.
b. as close to the left of the page as possible.
c. as close to the top of the page as possible.
d. in the center of the page.
2.
To perform a 3-minute transmission for field wire operation, what position must the
ANLG/ANLG(V) DIGITAL and HI RES LO SP/HI SP LO RES switches be placed?
a. ANLG/HI SP LO RES.
b. (V) DIGITAL/HI RES LO SP.
c. ANLG (V) /HI RES LO SP.
d. ANLG/HI RES LO SP.
71
Previous Page
