7.
The accuracy of all calibration standards and TMDE will be traceable
to the
a.
Electronics Command.
b.
US Army Standards Laboratory.
c.
National Bureau of Standards.
8.
Which equipment is used to measure the characteristics of materiel?
a.
Test measurement and diagnostic
b.
c.
Transfer standards
9.
What standard represents the source of the MOST accurate measurements
within the Army calibration system?
a.
Secondary transfer
b.
Secondary reference
c.
Primary reference
10.
Where is the Army Metrology and Calibration Center (AMCC) located?
a.
Redstone Arsenal, Alabama
b.
Philadelphia, Pennsylvania
c.
Washington, DC
11.
The purpose of a calibration
technical
bulletin
is
to
provide
instructions on how to
a.
Perform periodic calibration of a test instrument.
b.
Complete calibration forms and reports.
c.
Determine the calibration interval.
d.
Operate calibration standards.
12.
Who is responsible for assuring the
accuracy of
a
direct support
unit's organizational TMDE?
a.
Calibration team chief
b.
Calibration liaison officer
c.
Unit commander
13.
Valid transfer of accuracy from a supported Army unit through the Army
Calibration System to the National Bureau of Standards is called
a.
Certification.
b.
Metrology.
c.
Traceability.
14.
Elimination of a requirement to comply with an established operating
procedure or method of operation is called a
a.
Deviation.
b.
Waiver.
c.
Certification.
15.
Which organization contains both AACL and ATST?
a.
USASL
b.
ICRC
c.
ACRC
24
Previous Page
