t. Place
the
RANGE
NAUTICAL
MILES
switch
51501
to
PREC
10
(Figure 16).
u. Adjust the PREC 10-MILE SWEEP control R1523 (Figure 18) to
position the 10-mile range mark (eleventh intensified line) to
correspond with the last grid line on the right (Figure 17).
4.
Using this checklist,
review
the
location
of
the
following
components and controls.
____ Control indicator group OA-2664/FPN-40.
(See Figure 4.)
____ Panel, power distribution SB-1116/FPN-40.
(See Figure 5.)
____ Indicator,
azimuth-elevation
range
IP-800/FPN-40.
(See
Figure 6.)
____ Control, radar set C-2074/FPN-33.
(See Figure 4.)
____ Synchronizer-generator SN-386/FPN-40.
(See Figure 4.)
____ Computer, navigational CP-338/FPN-33.
(See Figure 4.)
____ SCAN switch S305.
(See Figure 5.)
____ Grid line face plate.
(See Figure 6.)
____ SURVEILLANCE-FINAL APPROACH-HEIGHT FINDER switch S2802.
(See
Figure 7.)
____ RANGE, NAUTICAL MILES switch S1501.
(See Figure 14.)
____ PRECISION HORIZONTAL CENTERING control R1506.
(See Figure 8.)
____ PRECISION CENTER AZ control R1507.
(See Figure 8.)
____ EXPANSION AZ control R1510.
(See Figure 8.)
____ PRECISION CENTER EL control R1508.
(See Figure 8.)
____ EXPANSION EL control R1509.
(See Figure 8.)
____ ART AZ-OPERATE-ART EL switch S401.
(See Figure 9.)
____ Angle volts output test point TP405.
(See Figure 9.)
____ ARTIFICIAL ANGLE VOLTS control R402.
(See Figure 9.)
____ Ground test point TP419.
(See Figure 9.)
35
Previous Page
