6.
To what nominal voltage should the U2 Bias Adjust in the Input circuit
be set?
a.
+70 mV
b.
-70 mV
c.
+1.3V
a.
-1.3V
7.
What waveshape should be present at the output of the Schmitt Trigger
when a measurement is being made?
a.
Trapezoidal wave
b.
Positive going square waves
c.
Negative going square waves
d.
Depends on the applied signal
8.
The output of U4 in the Input circuit will cause U2 to turn off when
the signal level exceeds
a.
1.5
Vdc.
b.
2.5
Vdc.
c.
3.0
Vdc.
d.
3.5
Vdc.
9.
When the function switch is placed to _________, the Gate Reset line
goes High to set the Event Gate and Time Gate F-F.
a.
START
b.
STOP
c.
FREQ A
d.
PERIOD A
10.
For which mode does the Time Scaler count clock pulses only during the
time between a Channel A and a Channel B pulse?
a.
b.
Ratio
c.
Time Interval
d.
Totalize
11.
In the Ratio mode,
the
of
which
signal
determines
the
measurement time?
a.
Channel A
b.
Channel B
c.
Time Base
d.
None of the above
56
Previous Page
